Free Delivery


Free shipping on orders over £125 Net.

*(excludes Scottish Highlands, Northern Ireland, Eire, and Uk Islands)



All Our Products Are Competitively Priced
Without the Compromise On Quality.

Safe & Secure


Sagepay & Paypal is a safer, faster, more secure way to pay online.

8" Gather Hood 450mm x 225mm

In stock
  • 8" Gather Hood
  • C/W Spigott to Fit Stainless Steel Flexible Flue Liner
  • All in one Solution.

8" (200mm) Gather Hood Adaptor 450mm x 225mm

The gather unit is used at the base of the chimney where an open fire is situated

It has a 450mm x 225mm rectangle base with mesh to assist whilst fixing it to the chimney stack

More Information
Component Type Adaptors
Installation Guide:

This item is used Mainly on open fires where a Flue Liner has been fitted :

Secure your Flue Liner to the top of the Gather Unit , just slide your liner into the top of the Gather Unit and secure with Self tapping Screws through the Holes on the Outsaide of the Adaptor , then just make the Joint good by inserting Fire Cement or Silicone Sealant to seal .

Drill through the Mesh on the Bottom of the Gather Unit 2-3 times on each straight Lenght of Mesh as these are the holes you will need to line Gather unit up into position , Drill holes into brick work insert Raw Plugs and secure using screws through the Mesh : in some cases you may need to use a washer to help stop the Screw from going through the Mesh .

If you can see any Gaps around your Gather Unit you will need to seal these with Fire Cement or High Temp Silicone Sealant.

Recommended Fuels: Wood, Gas, Oil, Occasional House Coals
Building Regulations :

We recommend that all installations are carried out by a qualified chimney installer.

additional information on installation and requirements can be found below.

 pdf documentDownload Document J Regulations

Material : Stainless Steel
Vat no. 173389871- Company No. 08618240 - Registered Name: Chimney Supplies Ltd t/a NCS - Copyright © 2023-present National Chimney Supplies