7" Register Plate 12" x 36"

£31.49 Excl. VAT per item
In stock
  • 7" Register Plate - 300mm x 910mm
  • Centre Plate Adjustable from front to back by up to 30mm  
  • Complete with 2 x Angle Brackets for fixing
  • Galvenised Steel
  • Can be Cut to Required Size 

7" 175mm Register Plate 12" x 36"

The register plate is used to seal off the chimney stack at the bottom. It comes with an adjustable plate to make installation easy and with 2 x pre-drilled angle brackets for fixing. The plate is removable should inspection need to be carried out on the liner.

You are able to cut the register plate, should it be too large to accommodate the size of your stack. 

This product will support vermiculite and stop debris from within the stack coming down the chimney and damaging your stove.

More Information
Product TypeRegister Plate
ColourStainless Steel
MaterialGalvanised Steel
Installation Guide :

Register plate, the metal plate and supporting angle brackets will need cutting to size. Secure the brackets to the inside of the chimney (fixings not supplied) the single skin pipe from the appliance will need to pass through the adjustable centre plate.

Building Regulations

We recommend that all installations are carried out by a qualified chimney installer.

additional information on installation and requirements can be found below.

 pdf documentDownload Document J Regulations

Company Information:
We remain fully open to all our Customers
Copyright © 2018-present National Chimney Supplies, Inc. All rights reserved.