7" Gather Hood Adaptor 300mm x 300mm

£78.39 Excl. VAT per item
In stock
SKU
UFGH07
  • 7" Gather Hood
  • C/W Spigott to Fit Stainless Steel Flexible Flue Liner
  • All in one Solution.

7" (175mm) Gather Hood Adaptor 300mm x 300mm

The gather unit is used at the base of the chimney where an open fire is situated

It has a 300mm x 300mm square base with mesh to assist whilst fixing it to the chimney stack

More Information
Dimensions
Product TypeAdaptors
ColourStainless Steel
MaterialStainless Steel
Installation Guide :

This item is used Mainly on open fires where a Flue Liner has been fitted :

Secure your Flue Liner to the top of the Gather Unit , just slide your liner into the top of the Gather Unit and secure with Self tapping Screws through the Holes on the Outsaide of the Adaptor , then just make the Joint good by inserting Fire Cement or Silicone Sealant to seal .

Drill through the Mesh on the Bottom of the Gather Unit 2-3 times on each straight Lenght of Mesh as these are the holes you will need to line Gather unit up into position , Drill holes into brick work insert Raw Plugs and secure using screws through the Mesh : in some cases you may need to use a washer to help stop the Screw from going through the Mesh .

If you can see any Gaps around your Gather Unit you will need to seal these with Fire Cement or High Temp Silicone Sealant. 

Building Regulations

We recommend that all installations are carried out by a qualified chimney installer.

additional information on installation and requirements can be found below.

 pdf documentDownload Document J Regulations

Loading...
Company Information:
We remain fully open to all our Customers
Copyright © 2018-present National Chimney Supplies, Inc. All rights reserved.