6" 90° Bend Stove Pipe
- 6" Premium Vitreous Enamel Stove Pipe Bend
- 10 Year manufacturer Warranty
- Used for Burning Wood, Gas, Oil, Low Sulphur Coal, Pellets
- 1.2mm Thick
- Matt Black Enamel Coated
6" 90° Bend Vitreous Stove Pipe
This component is used when a 90° change in direction is needed in the flue run is required. This bend minimises the resistance to the flow of flue gases due to the angle created with the vertical axis.
|Designation:||EN 1856-2 T600 N1 W V2 L80100 G450NM|
You should not install any piece of Vitreous with-in 3 x the internal diameter from combustible material eg: plaster board ceilings/wood etc, a 6" diameter piece of Vitreous should be 18" away from combustible materials ,
Each joint made should be sealed with Fire cement. Vitreous Flue pipe is only to be used as a connecting piece of flue between the appliance (EG: woodstove) and the flue liner or chimney stack.
Please make sure you buy the correct Adaptor to connect your Stove pipe to Flexible liner or Twin Wall Flue System.
|Recommended Fuels:||Gas, Oil, Solid Fuels, Wood, Pellets, Peat|
|Building Regulations :||
We recommend that all installations are carried out by a qualified chimney installer.
additional information on installation and requirements can be found below.